© 2022 All Rights Reserved Turboweb Australia Pty Ltd. 2004202948, MULTI-FACETED END FOR ROOF TRUSS WEB. Pre-Cut Turb-O-Webs are manufactured using the Patented Multi-Faceted End. Metal-plate-connected wood trusses are typically manufactured with chords and webs of solid-sawn wood fastened together with metal plates. Big gains without capital expenditure.Ĭall us for more information- or to get started ! Fastrack your way to higher truss output as well. Purchase precut Turb-O-Webs and give your saw output a boost. There are more Turb-O-Webs used in Australia today than at any time during the 26 years they have been continually used in Australia. The ultimate limit to how many Turb-O-Webs may be used by any plant is the plant’s ability to cut the other three truss parts. After 26 years, it’s time for a re-think !Īny truss plant manager should know that truss jobs are about 50% webs and 50% chords and that about 50% of the webs in a job can simply be replaced by precut Turb-O-Webs. The design of trusses using precut Turb-O-Webs is is the same as designing trusses “normally”. Below is a detailed breakdown and, in most cases, an explanation of each type of truss.
Precut Turb-O-Webs tick some pretty big boxes, especially a 33% increase, considering that there is no requirement for any major capital expenditure. That is, for every three parts cut in-plant (counting both chords and webs) one Pre-Cut Turb-O-Web will bring the available parts to press to four.
It’s an established fact over 26 years that Pre-Cut Turb-O-Webs can supplement saw output by 33%. That truss is clearly designed to be installed above a fully bearing wall. Square openings can only be made in the center of the span. Simply incorporating Pre-Cut Turb-O-Webs into a plant will increase the supply of cut-parts to the press by around 33%. That truss also appears to be a gable, it's missing the angled web in that last section.
0 kommentar(er)
